Oesterreichisches Normungsinstitut Institut belge de normalisation Dansk Standardiseringsraad Suomen Standardisoimisliito, r.y.
Association française de normalisation Deutsches Institut für Normung e.V. The European Committee for Standardization (CEN), under whose supervision this European Standard was prepared, comprises the national standards organizations of the following countries:Ĭontents Cooperating organizations National forewordįoreword Introduction 1 Scope 2 General 3 Normative references 4 General tolerances 5 Indications on drawings 6 Rejection Annex A (informative) Concepts behind general tolerancing of linear and angular dimensions Annex ZA (normative) Normative references to international publications with their relevant European publications Table 1 - Permissible deviations for linear dimensions except for broken edges Table 2 - Permissible deviations for broken edges Table 3 - Permissible deviations of angular dimensions National annex NA (informative) Committees responsible National annex NB (informative) Cross-referenceĢ 3 3 3 3 3 4 4 5 6 4 4 4 Inside back cover Inside back cover The following BSI references relate to the work on this standard: Committee reference MTE 24 Announced in BSI News, October 1993 ISBN 4 2 Hellenic Organization for Standardization Technological Institute of Iceland National Standards Authority of Ireland Ente Nazionale Italiano di Unificazione Inspection du Travail et des Mines Nederlands Normalisatie-instituut Norges Standardiseringsforbund Instituto Portuguès da Qualidade Asociación Española de Normalización y Certificación Standardiseringskommissionen i Sverige Association suisse de normalisation British Standards InstitutionĪmendments issued since publication Amd.